On the other hand if you want to run your ffserver in debug mode then follow the command, ffserver -d -f /etc/nf Keep in mind one thing that your configuration file should be ok then only it will run. Thus ffserver is made of two elements that are Feed Elements and Stream Elements.īelow mentioned command is used for to start your ffserver. Where these media players are Windows Media Player, VLC Media Player and FFplayer. These feed elements are associated with Stream Elements to provide content for streaming.Īs shown above Stream Element 4 is providing two different profile streams one for player 2 and another one for player 3. These ffmpeg input content sources are streaming to ffserver input content. Stream Elementes = Stream 1, Stream 2, Stream 3 & Stream 4Īt the Input Section there are three ffmpeg input content sources (Source 1, Source 2 and Source 3) each connected with three different Feed Element of the ffserver. There are two sections known as Input Section and Output Section. These players can be VLC Player, Mplayer and FFplay etc.Īs shown above in the figure this is detailed diagram for implementation of ffmpeg for streaming a media content.
This streaming is done at different bit rates for different players. Thus input content from different ffmpeg input sources are received by the ffserver which then streams this received content for different players. These sources are directly connected to a single FFserver to provide the content as input.
These two ffmpeg input content sources can be anywhere in the world.
As shown above in the figure there are two FFmpeg content input sources for FFserver.
0 kommentar(er)
